Tusnami sound trax mp15 decoder series#

Enter Program Mode by pressing the PROG key to enter programming mode. Run the locomotive back and forth to make sure you have control over the locomotive.ĥ.

Be sure that address 03 is the active throttle, the one with the blinking smoke when you enter programming mode.Ĥ. Select address 03 on either the L or R Throttle. Place the locomotive to be programmed on the layout.ģ.

Tusnami sound trax mp15 decoder series#

Programming a 4-digit address using a DT40x series or DT500 throttleġ. Select a 4-digit placeholder address that can be remembered easily. With the default address of 03 and a 2-digit address is desired, a 4-digit address will first have to be programmed and then the final 2-digit address can be programmed. Soundtraxx does not allow an active short address to be programmed. OPS Mode Programming is write only for Soundtraxx Tsunami decoders. To change Normal Direction of Travel (NDOT) add one to the value in CV29. These instructions will not cover these additional values. There are many other values that CV29 can be programmed to. Values are 06 for 2-digit and 38 for 4-digit addressing. These CVs are AD1, CV17, CV18 and CV29.ĪD1 is the Primary ( short address) Default 03, Acceptable Values 1-127ĬV17, CV18 are the two CVs that make up the Extended ( long address), Acceptable Values 128 - 9983ĬV29 is for Decoder Configuration. The individual CVs that make up an address will need to be programmed individually. It will also work for other manufacturer's sound decoders. This article was originally written for Soundtraxx Tsunami decoders. OPS Mode Programming Soundtraxx Tsunami Sound Decoders